Wont come on. The brake light comes on as does the blinker, but reverse light no. This is just the passenger side. Any solutions?

Replaced the bulb?


Sent from my iPhone using Tapatalk

__________________
Automotive Electronics Engineer
2000 XLT 2.5L A/T
Mods:
Explorer OHC
Explorer Autodim Mirrors w/ Autolamps
Explorer Sport White Face Gauges

Burnt out light bulb.

__________________
2002 XLT Extended Cab 4.0

Also while you're removing the light fixture to check the bulb, inspect any wiring, you may have had a critter get to it or just a damaged wire in general, broken off at the connector (?).. Let us know

__________________
_______________________

My Build Pg. Threads
+ 93' Ranger Overlanding Build
+ 94' Ranger Bed Overlanding Trailer Build
+ 12° North Industries ~ I Support

Thanks guys, Sorry been away awhile. tested the bulb in other sockets and it works fine. Inspected wiring and it looks fine, but I must have some wiring issue on that side because the drivers side works fine

Your missing either the 12v reverse control voltage or its associated ground at the bulb socket. you would need a multimeter or test light to confirm which is missing,then determine where the problem is. That signal splits left/right in the harness near the spare tire carrier. I've had to replace tail light sockets in the past due to corrosion. There is major dirt and salt action going on in the taillight area.

__________________
2004 XLT 4.0L 4x4 Extended Cab 162K - Daily Driver
1988 XLT 2.9L 4x4 Standard Cab 228K - Gone