So here's what I'm working with:
These are the directions that go along with the Xpresskit PKALL:
These are the directions that go along with the Avital 4103:
I also found these instructions online for a similar BullDog system:
Sent from my SM-N910V using Tapatalk
----------
I don't care about any of the anti-theft stuff so if I can ignore any of those wires that'll be a plus. The door locks I can finish myself (haven't had any time). I would like to know what remaining wires are necessary for the remote start.
1)My first question involves D2D. I believe that allows me to connect to an external computer and read information from the ranger. I don't want/need to do that so I'm assuming I can install without D2D. The directions say to cut the connector but then connect to a +12V source. Is that a constant source or ignition ON source?
2) I have no idea what any of the satellite harness connections mean or where those wires would be located.
3) I don't plan on using any of the anti-theft stuff so the only wire I would need on the 5-pin remote start harness would be the tachometer input, right?
4) I also have no idea where to start with the 9-pin Main Harness.
Sent from my SM-N910V using Tapatalk