Power at inertia switch - no power at Fuel pump
Hi all,
I just bought a 2000 Ranger 2.5 L Manual. I have a bugger of an issue though and I have not found a suitable solution on the forum so far. Fuel pump went out three weeks ago. I replaced it and it drove for a week and then the truck would not start again. I hadn't replaced the filter or the pump screen so I thought maybe I had burnt up the old pump already.
I replaced the relay, pump, filter, and screen - still no start. The pump isn't priming, so it's not getting power.
The relay is getting power. If I jump it with a paper clip, the inertia switch is getting full power. If I jump the inertia switch, still no power to the fuel pump (black and pink wire, correct?).
Can you help me figure out what might be going on? I'm at my wits end. A wiring diagram would be amazing. Ideas on troubleshooting would be exceptional too.
Thank you
|