I am installing a New Brake controller on my 2004 Ranger Edge and looked what was here and it said the Green Wire. I looked at the stop light switch at the Break pedal and there are 5 wires. Do I use the light green wire at Pin #2, there is a green with stripe and looks like two other dark green wires. The controller manual says to use the "cold side (voltage only when pedal is pushed.)"
I figured out all the other wiring.
Thanks

__________________
2004 Ranger EDGE
Regular Cab
3.0 Engine
No Mods

You need to test the wires but it should be a dark green not the dark green with the red stripe

__________________
1999 Ranger 4.0 and extreme Snap-on tool fetish