Wasn't sure where I should of posted this but here we go. I have a 1993 Manual Ford ranger 2.3L. I'm putting in a new alternator today but I've also have had a lot of shaking back and fourth from engine to the tranny. Whenever I take off from being stopped or turning it feels like the whole engine and tranny are moving and about to fall out of place. When I replaced the clutch 2 months ago the tranny mounts were fine. I'm wondering if I should tighten down the engine mounts and if so is their a special way to do it? I don't want to ruin anything. Thank you for you'r help its really appreciated.

__________________
1993 2.3L 2wd

One or both of your motor mounts are probably broken And may have messed up the new trans mount.

__________________
2011 Ranger XLT 2x4,4.0 SOHC, 5 Speed Auto, 3.55 Rear. Oxford White.

Simplicity is the ultimate sophistication.

Torque it down till it breaks off, then back it off 1/4 turn.