Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > Ford Ranger Technical > Drivetrain Tech
Forgot Password? Join Us!


Reply
 
LinkBack Thread Tools Search this Thread

  #1  
Old 04-23-2012, 12:29 PM
Learning to use the forums
 
Join Date: Apr 2012
Posts: 2
Default I just replaced the clutch and assembly in my 85 Ranger.

I removed the shifter after putting the transmission in neutral and did my best to put it back in the same position. I got all the air out of the slave cylinder and there is plenty of petal pressure. The shifter seems to move the shaft/s in the tranny but the truck won't respond in any gear when the clutch is released.
__________________
85 Ranger
84 300SD
85 380SE
83 528e
Reply With Quote
  #2  
Old 04-23-2012, 03:45 PM
Ford Ranger Driver
 
Join Date: Nov 2011
Posts: 1,140
Default Re: I just replaced the clutch and assembly in my 85 Ranger.

Mabe the throwout bearings not comming back all the way, keeping the pressure plate from working as it should. Block the front wheels, in front and in back, jack up one rear wheel, put the trans in first, then roll under it and turn the drive shaft, if it turns real easy, its in nutural, if it turns hard its in gear, and your clutch is slipping.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
Replaced Clutch now won't shift cagiva General Ford Ranger Discussion 5 01-30-2012 03:01 PM
Replaced Clutch master cylinder now no start bodyman61 4-Cylinder Tech 5 02-03-2011 09:12 AM
just replaced clutch now im hearing a rod knock patrick69 4-Cylinder Tech 4 11-10-2010 06:33 AM
Replaced clutch pieces and have questions earnbud Drivetrain Tech 6 05-02-2010 07:49 AM
Just replaced clutch,can't get it to engage jesseranger Drivetrain Tech 0 04-27-2010 03:28 PM



Search Engine Friendly URLs by vBSEO 3.6.0 ©2011, Crawlability, Inc.