Can't plug clutch line in quick realease

madmark · #1 03-18-2012, 02:25 PM

My clutch was worn out so I replace clutch disk and pressure plate . I removed the clutch line from slave cilinder and following procedures on pushing the plastic sleeve all the way inside the quick realease and it came off perfect now I am trying to put it back on and it simply is not going all the way in to snap in place . I have looked in every single post in the forums but nobody seems to have this same problem . Please help!!

RIVERA · #2 03-25-2012, 09:50 PM

you need to get a screwdriver and use it to put leverage to push in

Redrocket · #3 03-26-2012, 07:02 PM

its due to pressure in the slave open the bleader on the slave and plug the line in.. you shoudent have to bleed the clutch as long as no air enters the bleader.. if that dont work make sure the plastic color is towards the back of the fitting sense we dont need it to be releasein the fiting any more.. and check to make sure the little teath look ok no bent ones.. that 1st option should do the trick tho