91 2wd ranger, A4LD auto trans problems.
I have been having what seems like a linkage problem. It has this problem one time and then maybe not for several weeks. I put it into gear and it goes into gear fine, but when you start out theres a clunking like sound which seems like its not fully in gear,(automatic trans), mainly when I'm taking off, it doesn't sound right like its slipping , but not, like no power, but after 2nd gear driving 27mph and higher it drives fine. Also sometimes I will put it in reverse, it goes into gear, but hit the gas and nothing. If I put it in drive then rev again and apply a little gas it may enguage suddenly with a clunking sound. I did have shifting problems this summer, I replaced the govenor a few months ago with the steel weight, also the intermedate servo and the od servo, and it worked fine. but I have always had this other problem no and then. also linkage looks fine, pass gear set ok, fluid changed 2-3 times + filter, and cooler. (I wonder if there is some sensor that can cause this)? or if I just need a rebuild, and where can I get a rebuild for under $ 500.00 I don't have much money and its a 1991,+ Its winter now here in Macomb michigan.
I live in michigan, I have a 91 ranger 2.3 eng,
2wd, A4LD Automatic Transmission, 95,000 miles.