Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Thread Tools Search this Thread

Old 06-21-2011, 12:30 PM
dirtbikrider505 dirtbikrider505 is offline
Learning to use the forums
Join Date: Jun 2011
Posts: 13
Exclamation Drive selector issue

My 93 3.0 V6 has a tranny leak, ive replaced the pan gasket and didnt fix it, then i figured out its the "shift shaft seal", in order to get to that seal you have to take apart the linkage that puts the truck into park neutral etc. i attempted to take it apart but was stopped by the SMALLEST key made, and couldnt pull it out. put it back together and everything was fine. took it to a tranny shop and they couldnt get the pin out either. figured id keep dumping oil in cuz they said theyd have to pull the tranny for a grand to fix it. 1 weak later my truck gets stuck in n and there is complete play in the shifter. you cant even feel the pegs where the selector rests. took pan off and the linkage was ALL messed up. out it back together and was fine. few days later, reverse doesnt work, figured out i have to put selector in reverse position and slightly lift up to engage reverse. What should i do ??

sorry for the long story ha
93' 4x4 single cab 3.0 V6 auto
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Can I drive my 1996 Ford Ranger (2 wheel drive, 6 cylinders) on the beach/dunes? Marc A. General Ford Ranger Discussion 9 01-19-2011 07:32 PM
01 Edge-2WD-SUSPENSION ISSUE-POSSIBLE TORSION BAR ISSUE angelomm Suspension Tech 13 11-18-2010 10:16 PM
Shift selector off Snakedude1973 Drivetrain Tech 3 09-28-2010 02:58 PM
I have a Ford Ranger with 4-wheel drive. Now the 4-wheel drive is stuck... James H Drivetrain Tech 7 04-15-2010 04:02 PM
will a frontwheel drive Mercury motor fit into a rear wheel drive Ranger? Waupee Other Engine Tech 1 11-29-2008 02:57 PM