Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Thread Tools Search this Thread

Old 01-15-2011, 05:15 PM
winks winks is offline
Join Date: May 2010
Posts: 434
Send a message via AIM to winks
Default CV re-install - Need help ASAP

I have just replaced the axle seal on the passenger side of my truck. I have popped the CV back into place, but I can't tell if it's in the right spot. There is about a 5/16" gap between the CV and the axle housing. I have tried pulling the CV out, rotating it and putting it back in, but it doesn't want to go any further. Does this seem right, or is there something that I'm not doing here.

2004 Ford Ranger Edge manual 4.0 4x4 with 3" Body lift, 33x12.5 BFG A/T KO's, on Eagle Alloy 057 rims, and alot of mods
2011 Ford Mustang GT 5.0 manual with Flowmaster American Thunder exhaust
2005 Ford F250 automatic 5.4 4x4 with no mods
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
clutch install help 04, 2.3, ASAP 04rangernyc Drivetrain Tech 1 11-01-2010 05:34 PM
Need help asap< clutch install!!!!! 04rangernyc Drivetrain Tech 3 10-31-2010 10:37 AM
Need help ASAP!!!!! 98rangerxlt Drivetrain Tech 2 06-09-2010 10:05 PM
Need help asap!! Milla709 3.0 Vulcan Tech 7 06-04-2010 10:04 PM
Need Help ASAP! Ranger01 Exterior Tech 12 11-20-2009 05:24 PM