Hey guys, I took apart my valve body on my 5r44e yesterday and I have some questions
1. The gasket was blown out in one spot, what problems does that cause?
2. Are all the valves supposed to come out? (Some of the valves would slide a little and then stop dead and not come out)
3. I got a valve pushed in too far and it's stuck and I can't get it out, I included a picture. Any ideas on how to get it out?
Thanks for any help

Attached Images

20180505_215456.jpg (89.8 KB, 8 views)

https://www.sonnax.com/tech_resource...ve-body-layout Take a look at this page, you probably allready figured it out. I have a 4r44e valve body from my previous tranny atempt to repair, then went manual. When I get home I'll take a look at it, they are very similar. Be carefull with the internal wiring harness, the insullation of each wire use to deteriorate cause of the oil.
I paid 175.00 here in PR for a new body with every solenoid include. Good luck 👍