Not going into any gears...

[Socalranger99]

WHen car is turned off I can put the stick an any gear just fine with or without clutch being in gaged......when truck is started it will not go into any gears



please help me out

[Jswifto]

Probably s bad clutch slave or a bad clutch.

[tomboy]

What does the clutch petal feel like when pushed down, does it have resistance all the way, only has resistance near the bottom, or mushy all the way. And as stated, could be the clutch disk worn out, slave cyl leaking and has air in it, weak master cyl, with air in it also. Or the pilot bearing may have went bad causing it to lock to the input shaft.

[Socalranger99]

Originally Posted by tomboy

What does the clutch petal feel like when pushed down, does it have resistance all the way, only has resistance near the bottom, or mushy all the way. And as stated, could be the clutch disk worn out, slave cyl leaking and has air in it, weak master cyl, with air in it also. Or the pilot bearing may have went bad causing it to lock to the input shaft.

It has very little resistance imma bleed the clutch fluid this weekend and see if that helps

[Socalranger99]

Random side note: the truck drove just fine no issues with the clutch at all until it just stopped going into gear

[bjurke]

check for leaks but more likely pilot,slave or clutch which require dis-assembly to see where the problem lies. you should have resistance on the pedal all the way to fully extended.