Hello Ranger Owners,
I have a 2007 Ranger Sport. I installed an ARE tonneau cover with wing/brake light. The installer installed the cover but did not connect the brake light. I am electronically savage but for the life of me I can connect the brake light whereas the light only works when the brakes are depressed and not the turn signal. If you can shine some light on this matter, I will be thankful.


Al
Hinesville, GA

So the brake light on the topper works when you are on the brakes? Sounds like it's working to me.

__________________
Baby Girl: 2006 White Ranger XL with many memories. R.I.P. 1/26/15

My desire is that the light on the topper light only when the brakes are applied and not when the turn signal is switched on.

It's on with the turn signal too? That means they must have wired it into the brake lights on the bed.

Some info would be better, does it turn on with both left and right turn signals, or just one? If just one, then go to that light and figure out where it is tapped in, then relocate the wires to the CHMSL bulb.

__________________
Baby Girl: 2006 White Ranger XL with many memories. R.I.P. 1/26/15

I wire the light n the wing to the left bed light group. I maybe should locate the wires for the brake light on the cab and make the connection there.

You need to wire it to the wire that only has power then the brakes are pressed.

__________________
1997 B2300 reg cab 2.3 Lima, 15x8.5 Mickey Thompson classic 2, 31x10.50 cooper discover at3, 7.5 open 4.10 rear, dynomax super turbo catback, alpine iva-w200 w/ nav, kicker 6x8s, alpine type R 8, alpine 250W mono amp, power bass 400.4, tool box & camper shell, compustar alarm/remote start.
1956 Ford F100 rust bucket with big plans!