Things they don't tell you about a V8 swap
Anyone that has done a V8 ranger, dreamed of doing or is in the process has read the TRS article "Swapping An Explorer 5.0L In To A 1998-Up Ranger"
I have some additions, things they left out that might be helpful.
They: "Using the Explorer 5.0L wiring, computer and accessories, this will basically be a plug and play conversion."
Add this: "after you have done it 3 or 4 times"
They: "The two biggest problems you could run in to doing this swap would be the PATS and VSS."
Add this: "There will be tens of dozens of little problems you will face also"
They: "The easiest V8 donor for a 1998-2007 Ranger 4x4 swap would be the 1996-2001 Explorer/Mountaineer 5.0 AWD."
Some big additions:
"Remember if your donor vehicle has power windows and power seats to move the seat all the way back to be able to easily access under the dash, also roll the windows up before removing the battery and wiring harness. Failure to do so will result in animals making homes inside, mammals as well as stinging insects especially if you leave it sitting for most of a year in an open field."
"If you leave the transmission in the donor and pull the motor only, do not remove the transmission dip stick tube until you have everything you want to remove by crawling under the vehicle first. Having 10 gallons of floor dry or kitty litter works also but not as easy."
"The temperature sensor for the overhead console is not necessarily in the spot that every article on the internet says it is. It might just be on the driver side."
"The most likely place for a huge mud based wasp nest it behind the dash to the right of the instrument cluster. Being able to run quickly will minimize bodily damage. There might also be additional hornet nests in the door panels if you leave them open."
Now on the vehicle the motor is being installed in.
"Make sure you are not following the 4 wheel drive V6 tutorial if doing a coil spring 2WD ranger born with a 4 cyl, you will waste a lot of money on wrong mounts, wrong plates and general headaches on every detail. Good luck finding 100% reliable info on the coil spring swaps even from people who design the mounting plates. Plan on spending 3 or 4 times the money you budgeted, plan on it taking at least 10 times longer than the articles you will read."
Maybe eventually I will finish it. I hope.
__________________
00 XLT 4WD XCSB 4.0 my new baby
00 XLT 2WD RCSB 5.0 swap in progress.
98 XLT 4WD XCSB 4.0 dead
99 EXPO donor motor for dead one and parts for the others.
Newest Ranger Forum
|