Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Reply
 
Thread Tools Search this Thread

  #1  
Old 08-26-2017, 11:20 AM
Atx Atx is offline
Ford Tough
 
Join Date: Jul 2011
Posts: 260
Default Blowin out header gaskets ?

So I'm so tired of blow out gaskets on the passenger side flange . Flange is thick and seems to set flush from the naked eye but has to be some what warped or the header bolt holes are not large enough and hitting the sides when tightened down . I've checked length since I've replaced half the bolt with chevy bolts so to falling over time . I've locked tighted everyone since then and re tightened. I don't have flex pipes yet and so the exhaust is pretty stiff including mounts . Anyone else have this kinda issue and figured out a solution that worked .
Ive been using paper and composite type gaskets and even doubling them up . Today I say a set of solid aluminum gaskets . Mr gasket 7401g anyone use them . There $30 so I may just give them a try and see



Sent from my iPhone using Tapatalk
__________________
87 rx7 street port w/holset hx52 turbo
2008 tbss 6.0 ls2 cam'd
94 xcab 5.0 swap in progress

Last edited by Atx; 08-26-2017 at 11:23 AM.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
if you had $500 to blow, what would you buy? CitySlick General Ford Ranger Discussion 180 11-21-2013 07:11 AM
Ac doesnt blow jpranger97 Interior Tech 0 06-24-2013 05:53 PM
How to fit two 10's or help with a blow through Tabrown Audio / Video 19 02-11-2013 07:41 AM
How bad is your blow off? JRock Suspension Tech 5 10-18-2012 07:52 PM
Blow through!!!!! austinbailey Audio / Video 27 09-03-2012 04:43 PM