View Single Post
 
Old 07-30-2011, 08:30 AM
RMZpilot RMZpilot is offline
Like the Forums
 
Join Date: Feb 2011
Posts: 45
Default Ignition Module Install

Finally got around to replacing the ignition module on the back of the distributor after my 1990 starting to act odd.

What do I use on the plate that mounts against the distributor? It had something on it from the factory, not sure if it was die-electric grease or what it was.

It runs much better, for a while... Specifically until it loosens and starts falling out because I lost BOTH screws. Im sure they are out of sight on the back of the motor somewhere! Gotta get new screws today, anybody know exactly what kind of screws I need, cause I never even got a look at them.

NOTE: Use a magnetized tool to get those screws out. Or pull the distributor like the manual says...
Reply With Quote