I have a 95 Ranger and my ABS light comes on intermittently although its come on more often than usual recently. I checked the flash code and I got code #12. My Haynes manual doesn't say anything about ABS codes buy my Chiltons manual doesn't help much either.

i have a 95 2wd with rear abs and my light came on but my abs still works?! i just pulled the bulb out of my guage cluster. its nothing to worry about lol your brakes are fine!

uhhhhhhhhhhh

__________________
1998 ford ranger STOCK http://www.facebook.com/Iddipthat

Its not so much that my ABS isn't working, I just hate looking at lights on my gauge cluster. I just was wondering if there is a quick fix so I don't have to tear apart my dash to take the bulb out. Ive taken the dash apart several times before to replace bulbs, replace headlight switches, but I don't like taking it apart.

You try resetting the fault codes by unplugging your battery?

__________________
2008 Ranger XLT 4cly 2.3l, 2wd Fabtech 5.5 Bastard psck 31x10.5r15 BFG All Terrains, Smoked tail lights and front corners, Hid Headlights, Dumped Flowmaster 40 series, Air box mod, CB Radio 5ft Firestick,Blue Led in cab, New Memphis speakers Kenwood amp and stereo
Soon To be 8.8 4:10 ls Swap

Mine has a code 12 but it is related to the airbag. Your abs light can be cause by several things. Vehicle speed sensor, abs module, low brake fluid...

__________________
'95 Yellow 2.3 liter, 5 speed manual Splash Edition
'11 Mustang 5.0, 3.73's, 6 MT, Hushpower axle-backs, Eibach Pro springs, CDC Center Fog Grille

Crawl under your truck, and gently wiggle the sensor(s), and make sure they are on completely. Mine did this, and when I did the above it went off, and has stayed off. Might just be as simple as the connection being loose.

__________________
Cree Proverb

~Draw me not without reason, Sheath me not without honor~ 17th century swordmaker Gallegos

~1994 Ford Ranger 2.3L 4-Banger 217, 000+miles~

Well I checked my sensor and wiring and they were all good. I even tested the resistance in the sensor and it came in the range of the proper resistance stated in the Chilton manual. Finally I took off the wiring by the brake fluid reservoir and sprayed some contact cleaner on the electrical connections, and that has done the trick. No more ABS light.

Wow that's bad advice

__________________