 |
 |
 |
|
#1
12-31-2009, 06:11 PM
|
|||
|
|||
Help, please. wire broke
I replaced the ignition control module and now the truck will not start. There is a broken wire in the lower harness on the right in the pic and I have no idea where it goes. The wire color on the connector was tan and very corroded. It's a 94 2.3l 4ngine, and it cranks over fine, fuel pump on. all new plugs and wires and coils, and this was the last thing I replaced.
Last edited by rumpranger; 12-31-2009 at 06:17 PM. 
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#2
12-31-2009, 06:22 PM
|
||||
|
||||
|
go find another harnes, cut the new harnes and splice your wires together make sure there is enough wire remaining on the new harness where you can sucessfully put the two wires together. hope this helps
__________________
2001 ford ranger XLT/4.0 sohc./160,000 Mods:Cb/recon third brake light/air silencer mod/new door speakers and h/u / shorty console, 245-75-16 goodyear wrangler duratracs on rock crawler rims. hellas and 03 honeycomb grille. Quote:
Quote:
|
|
|
|
|
|
#3
12-31-2009, 06:32 PM
|
|||
|
|||
|
The thing is that I dont know where that broken wire goes to! It is actually orange with a yellow stripe...the broken one
|
|
|
|
|
|
#4
01-03-2010, 05:07 PM
|
|||
|
|||
|
Anyone??? Someone here has to have a 2.3 engine that can at least trace which other harness that wire goes to!
|
|
|
 |
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parking Brake Broke | Bear | Drivetrain Tech | 6 | 05-20-2010 12:29 PM |
| Broke what I assume is the bypass hose mount (3.0L) | FrequentFlier | 3.0 Vulcan Tech | 2 | 01-21-2010 09:47 PM |
| fly by wire gas peddle | blueovelboy | 4-Cylinder Tech | 3 | 09-21-2009 10:23 PM |
| I think its broke....:( | baldy3220 | 4-Cylinder Tech | 3 | 09-03-2009 08:13 AM |
| 12v Wire | benb70 | Electrical Tech | 5 | 08-04-2009 04:30 PM |
|
|
 |
|
|
 |
 |
 |
