 |
 |
 |
|
#1
10-24-2010, 09:17 PM
|
|||
|
|||
2.3 rebuild
How difficult is it to rebuild one of these? Would it be worth getting a Haynes?
__________________
1997 Ford Ranger 2.3L That's in the junkyard. Still a member to help with my friends. 1998 Ford Ranger 3.0L 5-speed 
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#3
10-28-2010, 01:18 PM
|
|||
|
|||
|
Re: 2.3 rebuild
I'm nearing the end of a complete rebuild. other than having problems trying to figure out where everything goes, I have had no problem. as for the Haynes, I have seen better books.
As to the question I am having, I have this empty hole that needs something in it. It is right behind the dipstick, and below the oil pressure sender (in the lower block) and appears to be a for a sensor of some kind. (see attached photo)
__________________
86 2.3l EFI 4 speed +overdrive 2wd club cab Last edited by MarKFK; 10-28-2010 at 01:20 PM. Reason: grammar
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ah hell what am I doing 2.3t rebuild lol | mikesturbo94 | 4-Cylinder Tech | 58 | 06-27-2011 04:42 PM |
| can I rebuild my distributor? | Sal | 3.0 Vulcan Tech | 1 | 07-25-2010 12:58 PM |
| Trans rebuild or replace? | 98offroad | Drivetrain Tech | 0 | 07-14-2010 01:27 PM |
| 2.9 rebuild project. | Roadkill | 2.9 Liter Tech | 1 | 05-24-2010 07:09 AM |
| 4.0 rebuild | chugalugz | 4.0 SOHC / 4.0 OHV Tech | 2 | 03-30-2010 09:18 AM |
|
|
 |
|
|
 |
 |
 |
