 |
 |
 |
|
#1
07-05-2010, 06:15 PM
|
|||
|
|||
can't get crankshaft pulley off 1997 2.3l engine!
I first had problems removing the crank shaft pulley bolt. I finally got the bolt loose. How I have been trying to remove the pulley itself. That bad boy is on there! any ideas on how to remove the puley?
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#2
07-05-2010, 06:20 PM
|
||||
|
||||
|
Re: can't get crankshaft pulley off 1997 2.3l engine!
Are you using a puller?
|
|
|
|
|
|
#3
07-08-2010, 02:58 PM
|
|||
|
|||
|
Re: can't get crankshaft pulley off 1997 2.3l engine!
I had the same problem. The answer: heat. I got by with a small propane torch, but if its really on there you may want to try an oxy-acetylene torch.
__________________
1997 Ford Ranger XLT short bed regular cab 2.3L Lima 5 speed manual
|
|
|
 |
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crankshaft sensor install | RandSand | 4.0 SOHC / 4.0 OHV Tech | 2 | 01-26-2010 09:24 PM |
| Need help with 2.3 crankshaft pulley | Stang1986gt | 4-Cylinder Tech | 0 | 12-08-2009 07:45 PM |
| crankshaft pulley | ranger danger | General Ford Ranger Discussion | 2 | 11-21-2009 09:21 AM |
| 1997 3.0 to 5.0 or similar engine swap and tranny | 97Ranger | 8-Cylinder Tech | 3 | 10-20-2009 07:50 PM |
| How to remove Crankshaft Pulley + Hub? | 4 banger ranger | 4-Cylinder Tech | 11 | 10-07-2009 08:34 PM |
|
|
 |
|
|
 |
 |
 |
