 |
 |
 |
|
#1
01-03-2015, 12:47 PM
|
|||
|
|||
1993 ford ranger 2.3l cam ideas?
Just bought 1993 Ford Ranger Standard cab 5 speed. Did a compression test and piston 2 had no compression and so I performed a wet test and it resulted a 50. So I plan on rebuilding it and while i have it pulled apart gigured i would just put an upgraded cam in at the same time. Looking for some speed with some power also. Any ideas advice and comments are welcome. Thanks!
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#2
01-03-2015, 05:05 PM
|
||||
|
||||
|
Cam options are available but all are rather pricey, Esslinger, Boport, crane, fms.
__________________
MY BUILD THREAD  1999 MAZDA 2500SE, 2.5L 4-clanger, 5 speed, Green n slow. Rangers as daily drivers since 1988. ASE Certified Mechanic, Builder of Show Destroying Protouring and Classic cars..
|
|
|
 |
|
|
| Tags |
| 2.3l 4cyl, camshaft, upgrade |
|
|
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 92 Ford Ranger XLT 4.0 OHV Cam? | porter118 | 4.0 SOHC / 4.0 OHV Tech | 0 | 06-28-2014 10:12 AM |
| 1993 ford ranger | ghostmarine17 | General Ford Ranger Discussion | 4 | 11-27-2012 08:50 AM |
| 1993 ford explorer tranny and rear axle for my 1993 ranger? | TeeJay88 | Drivetrain Tech | 3 | 03-12-2012 07:48 PM |
| 1993 Ford Ranger XL | MichaelFarrer | Introduce Yourself | 6 | 02-07-2012 02:25 PM |
| 1993 ford ranger 2.3 | pvcooper | 4-Cylinder Tech | 2 | 01-02-2010 08:06 PM |
|
|
 |
|
|
 |
 |
 |
