My ranger will turn over and has a good battery but will not start. I checked for spark on all wires nothing. I pressure tested the fuel pump no pressure. I jumper wired the fuel relay and have fuel pump coming on.I checked the crank sensor and it seems fine but I am getting no voltage to the leads into the crank sensor. I have not tested the cam sensor yet but without voltage to the crank sensor I don't know what else to check. Any help would be greatly appreciated.

__________________
black 1997 ford ranger s-cab 4X2 4.0
redorange 1999 ford ranger s-cab 3.0 flex fuel
------------------------
"It won't start; your not holding your mouth right!"
-DW 2003

Check all fuses?!

__________________
2000 Extended Cab XLT 2WD
3.0 V6 Flex Fuel...Pioneer Deck w/ Pink LCD screen....Mustang Dome with LEDs Thanks BuggMan!
Needs installed:Explorer OHC with Green LEDs

Yeah I checked all the fuses. I have not checked the relays themselves but I took the relays out of my explorer which has the same relays and engine and still nothing.

__________________
black 1997 ford ranger s-cab 4X2 4.0
redorange 1999 ford ranger s-cab 3.0 flex fuel
------------------------
"It won't start; your not holding your mouth right!"
-DW 2003

Check your grounds. That could cause all of these problems and more.

__________________
2000 XLT 4x4, 4dr ext cab, 4.0L OHV, 4.10 LSD
265/75/16 Goodyear Duratracs
Mountaineer seats, Expo OHC
2003 EDGE front clip conversion
133rwhp/192rwtq-->6-28-11

1969 Mercury Cougar
351W, FMX, 3:1 open diff in a Ford 9"
Undergoing restoration

thanks will do.

__________________
black 1997 ford ranger s-cab 4X2 4.0
redorange 1999 ford ranger s-cab 3.0 flex fuel
------------------------
"It won't start; your not holding your mouth right!"
-DW 2003

your crank sensor will provide voltage when the flywheel spins. if your sensor is bad, it will cut off all of your said issues. no fuel and no spark

__________________
2007 FORD RANGER XLT EXTENDED CAB - 4.0, 4x4, 5sp
Ultragauge, 10" L7 W/ 2200W PA Amp, CB W/4' Fiberglass whip, PA system, LEER shell w/led 3rd brake and custom remover, LED taillights in mudflaps, 5K 55W HIDs, Aux reverse lights, DIY bed liner, Hellas, Bed mat (cut up livestock mat).

well I checked all my grounds, replaced the cranksensor because the other one tested bad. I still got no spark or fuel so I checked on the pcm because a friend told me it could be the problem. I pulled it out and it was fried so I think I found the main problem. I am going to get get one this weekend but I wanted to know if anyone had a good place to get a pcm and should i get a junk yard one or from an aftermarket place?

__________________
black 1997 ford ranger s-cab 4X2 4.0
redorange 1999 ford ranger s-cab 3.0 flex fuel
------------------------
"It won't start; your not holding your mouth right!"
-DW 2003