|
|
|
|
12-10-2014, 02:39 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
98 ranger 4.0 OHV won't run
Ok so to start of the truck (98 ranger 4.0 OHV 5 speed 2wd) broke down 3 or 4 months and we have tried everything to get this thing going and before i spend anymore I want one other opinions. So it started with a slight miss and over the coarse of a few months and got worse and worse until it stopped running. It was destroying fuel pumps once every other week.(everytime I changed one it ran better but still not perfect) so we though it was the heads, we pulled them off and they were cracked. Got some off of another truck. Had a good family member inspect them, (professional) said they were good, put them on, changed all gaskets, still didn't run. Did a valve job and checked the rings, everything was fine. Still doesn't run at all. Its fueling and its firing but has low compression. You can barely make it start. Camshaft position sensor is good. Crank sensor is good. Timing chain is good. Its in time. Our next guess was PCM. Maybe its bad? Truck only has 115xxx. Anyone else ever dealt with this?
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
Last edited by derekq34; 12-10-2014 at 07:44 PM.
Reason: forgot some imformation
|
|
|
|
Register and never see these ads again. |
|
12-10-2014, 02:54 PM
|
Ford Ranger Driver
|
|
Join Date: Nov 2012
Posts: 1,574
|
|
Re: 98 ranger sohc won't run
Is the compression low on all cylinders? Low compression isn't going to be a sensor problem, but a mechanical one...either with the rings, block, piston, valves, heads, or head gaskets.
__________________
2000 Ford Ranger XLT
Extended Cab
3.0 Flex
4x4
Manual Transmission
Offroad Package
|
12-10-2014, 03:03 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
Re: 98 ranger sohc won't run
Yes. Has low on all cylinders. But we already checked everything. Heads arefine, valves are fine, rings are perfect, pistons fine. Block is fine. When it was still running it ran on one cylinder. Missing on 5
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
|
12-10-2014, 03:04 PM
|
|
smart @$$ 101
|
|
Join Date: Jun 2014
Posts: 1,875
|
|
Re: 98 ranger sohc won't run
if you were blowing through pumps like that, id start tracing the fuel system... electrical and all...check your lines and stuff for clogs etc.
__________________
2001 f250 7.3 zf-6
1979 f150 400/c6
Ranger free since December 2015
quote of the day:
The round flowing fenders of this vehicle have been lovingly reconstructed by a Dutch craftsman out of, what could be considered the most precious material on earth, bondo
|
12-10-2014, 03:09 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
Re: 98 ranger sohc won't run
Fuel pressure at the Schrader valve is fine. Checked all fuel parts front to back. No vaccum leaks. Nothing
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
|
12-10-2014, 03:10 PM
|
|
smart @$$ 101
|
|
Join Date: Jun 2014
Posts: 1,875
|
|
Re: 98 ranger sohc won't run
did you check the electrical components?
__________________
2001 f250 7.3 zf-6
1979 f150 400/c6
Ranger free since December 2015
quote of the day:
The round flowing fenders of this vehicle have been lovingly reconstructed by a Dutch craftsman out of, what could be considered the most precious material on earth, bondo
|
12-10-2014, 03:13 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
Re: 98 ranger sohc won't run
Yes, with a test light that can put power to what it touches
----------
Also it throws a p1000 code
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
|
12-10-2014, 03:15 PM
|
|
smart @$$ 101
|
|
Join Date: Jun 2014
Posts: 1,875
|
|
Re: 98 ranger sohc won't run
what does it do when you try to start it?
__________________
2001 f250 7.3 zf-6
1979 f150 400/c6
Ranger free since December 2015
quote of the day:
The round flowing fenders of this vehicle have been lovingly reconstructed by a Dutch craftsman out of, what could be considered the most precious material on earth, bondo
|
12-10-2014, 03:17 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
Re: 98 ranger sohc won't run
It spins over for awhile and you can toy with the throttle and make it run for a few seconds, then it dies off. Doesn't lose fuel. Just doesn't really have enough compression to run
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
|
12-10-2014, 03:21 PM
|
|
smart @$$ 101
|
|
Join Date: Jun 2014
Posts: 1,875
|
|
Re: 98 ranger sohc won't run
our shop Durango was doing the same thing, some of the plug wires were switched around, and a ******* forgot to tighten the plugs. are all of the plugs snug? try undoing all of the wires and putting them in order again.
__________________
2001 f250 7.3 zf-6
1979 f150 400/c6
Ranger free since December 2015
quote of the day:
The round flowing fenders of this vehicle have been lovingly reconstructed by a Dutch craftsman out of, what could be considered the most precious material on earth, bondo
|
12-10-2014, 05:09 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
Re: 98 ranger sohc won't run
okay all that's correct.
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
|
12-10-2014, 05:13 PM
|
|
Mustang Owner
|
|
Join Date: Mar 2012
Posts: 14,046
|
|
Your motor isn't the sohc its a OHV
__________________
2017 Lightning Blue Mustang GT PP 430/402
CJ Pony Parts Lowering Springs | Texas Speed Longtubes | PMAS CAI | Lund Tuned | Borla S-Type Catback
2013 F150 FX4 5.0 - Sold
1998 Jeep Wrangler TJ 4.0 5spd - Sold
2001 Mustang Bullitt - Sold
2005 Level II - Sold
2001 Integra GSR - Sold
1999 XLT - May 2013 TOTM - Totaled
Quote:
Originally Posted by 2004 fx4 level II
fuckin Nissan shhhiitttttttttt!!!!!!!!!!!!!!!!!!
|
|
12-10-2014, 06:22 PM
|
Liking the Ford Ranger Forum
|
|
Join Date: Dec 2014
Posts: 26
|
|
Re: 98 ranger sohc won't run
actually it's not
__________________
98 ranger 306 FI 35s 2wd baja fenders 4 inch lift
|
12-10-2014, 06:26 PM
|
|
Mustang Owner
|
|
Join Date: Mar 2012
Posts: 14,046
|
|
Quote:
Originally Posted by derekq34
actually it's not
|
unless its motor swapped it is NOT a sohc.
__________________
2017 Lightning Blue Mustang GT PP 430/402
CJ Pony Parts Lowering Springs | Texas Speed Longtubes | PMAS CAI | Lund Tuned | Borla S-Type Catback
2013 F150 FX4 5.0 - Sold
1998 Jeep Wrangler TJ 4.0 5spd - Sold
2001 Mustang Bullitt - Sold
2005 Level II - Sold
2001 Integra GSR - Sold
1999 XLT - May 2013 TOTM - Totaled
Quote:
Originally Posted by 2004 fx4 level II
fuckin Nissan shhhiitttttttttt!!!!!!!!!!!!!!!!!!
|
|
12-10-2014, 06:29 PM
|
|
ford dealer parts guy
|
|
Join Date: Apr 2011
Posts: 20,938
|
|
Re: 98 ranger sohc won't run
Quote:
Originally Posted by bigfisher
unless its motor swapped it is NOT a sohc.
|
^^^
__________________
2021 F150 5.0 Screw
Past:18 F150 2.7, 16 F150 5.0, 14 F150 5.0, 07 F150 5.4, 03 Ranger 4.0
Master Certified Ford Parts / Warranty Admin
|
|
|