 |
 |
 |
|
#1
02-08-2010, 07:08 AM
|
|||
|
|||
Flex fuel
I have a 1999 ranger 3.0 flex fuel and have a flex fuel sensor code.
I was about to change the sensor when I checked the voltage at the wires. I have read that I should have 12 volts on one wire, 5 volts to a 2nd and the 3rd is ground. I have 12 volts to 2 and the 3rd is ground. any help would be appreciated. Thanks Bob 
|
 |
 |
| Register and never see these ads again. | |
|
|
 |
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3.0 flex fuel egine swap | postup610 | 8-Cylinder Tech | 2 | 11-29-2009 07:07 AM |
| Sorry if this is in the wrong forum. How do I tell if I have flex fuel 3.0 | worldclasssniper | 3.0 Vulcan Tech | 16 | 11-11-2009 01:03 PM |
| 3.0L Flex Fuel 6 cyl - tow capacity | hmcqueary | 3.0 Vulcan Tech | 3 | 10-30-2009 11:13 AM |
| Lockign Gas Cap 3.0L flex fuel | hmcqueary | 3.0 Vulcan Tech | 3 | 10-26-2009 12:53 PM |
| 99 v6 3.0 flex new fuel filter | jim22 | General Tech | 1 | 08-22-2009 07:42 PM |
|
|
 |
|
|
 |
 |
 |
