 |
 |
 |
|
#1
03-15-2011, 07:19 PM
|
||||
|
||||
preparing head surface 3.0
I remove the head because of that stupid broken bolt on the side of exhaust manifold, i already done that, i just need some tips/advice how to prepare the surface of the block and the head when putting back, to those who did this before,and things i need to check while this thing is open, i know you would suggest camshaft sensor assembly but its not chirping or CEL on it, and dont have money for that right now,i only did one side as thats where the broken bolt is hope you guys could share your experience!
[IMG]  Uploaded with ImageShack.us[/IMG][IMG]  Uploaded with ImageShack.us[/IMG] Uploaded with ImageShack.us [IMG]  Uploaded with ImageShack.us[/IMG]
__________________
1997 Ford Ranger 3.0 V6 2WD Nothing special lol, 
|
 |
 |
| Register and never see these ads again. | |
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.0 head swap | goofin | 4.0 SOHC / 4.0 OHV Tech | 1 | 12-30-2010 07:42 PM |
| Need help with head unit | CLJ99ranger | Audio / Video | 12 | 12-23-2010 05:35 PM |
| Want to Buy: head unit | DangaRanger | Interior Parts | 2 | 07-20-2010 09:09 AM |
| What's the best way to fix surface rust? | drewglenn04 | Exterior Tech | 3 | 04-29-2010 09:09 AM |
| I need a head | Phil | 4-Cylinder Tech | 2 | 03-20-2010 11:11 AM |
|
|
 |
|
|
 |
 |
 |
