 |
 |
 |
|
|||||||
 |
 |
|
|
 |
|
|
|
|
Thread Tools | Search this Thread |
|
|
|
|
|
#1
12-05-2010, 03:10 PM
|
||||
|
||||
Bolt in P/S pump pulley, does it come loose clockwise or counterclockwise?
I need help once again. I just swapped engines on an '02 Ranger Edge 3.0 but the power steering pulley broke on me (long story). All I need to know is how to remove that pulley (whatever's left of the old one) and install a new one. I'm guessing I have to take out the bolt in the center which is a 3/8 hex. Now, does it come out like any normal bolt comes out (lefty loosey) or is it clockwise? Any input will be greatly appreciated.
Last edited by MAILMAN; 12-07-2010 at 05:29 PM. Reason: Delete 
|
|
|
| Register and never see these ads again. | |
|
|
|
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crankshaft pulley bolt 2.5L | ecogenie | 4-Cylinder Tech | 10 | 03-18-2017 06:56 AM |
| Replace Power Steering Pump (Pulley Removal) | bolivartech | 4-Cylinder Tech | 12 | 11-02-2010 06:58 AM |
| Luck just turned for the worst...bolt of water pump bolt | dixie_boysles | 4.0 SOHC / 4.0 OHV Tech | 7 | 07-13-2010 09:10 AM |
| stripped power steering pump pulley | vehder | 4-Cylinder Tech | 2 | 09-14-2009 11:39 AM |
| Is there a trick to get the crank shaft pulley bolt out of a Mazda | hunter j | General Ford Ranger Discussion | 3 | 12-19-2008 10:43 AM |
|
|
 |
|
|
 |
 |
 |
