View Single Post
 
Old 01-02-2011, 06:39 PM
terryduanemiller terryduanemiller is offline
www.shanewootenband.com
 
Join Date: Oct 2010
Posts: 1,896
Default Re: Hurst Shifter Ball Problem

Quote:
Originally Posted by drppdyllwrngr View Post
there should be a jam nut that goes down the threaded section first. thread it all the way down. then the ball goes one. screw it down as far as you want, with the numbers facing the way you want. then run the other nut back up and tighten the two together. it will "jam" the two nuts and hold them tight.



you can see it in the upper left corner.
I was assuming the knob didn't have a nut.. and the ball wasn't lining up when tight..
Wow, that's self explanatory, lol...
__________________
MY BUILD THREAD
1999 MAZDA 2500SE, 2.5L 4-clanger, 5 speed, Green n slow. Rangers as daily drivers since 1988.
ASE Certified Mechanic, Builder of Show Destroying Protouring and Classic cars..
Reply With Quote