Ok so i replaced the passenger side upper ARM with a new OEM UPPER ARM. No problem here... Straight forward and did final tightening of the upper arm bolts/nuts with wheel on the ground.


Driver side has a busted lower Ball joint boot....

Problem...

The BJ press i loaned from oreyleis only has 3 cups. Before removing bj i planned to see if i was gonna be able to press in the new OEM. i could have taken it out, but not press it in because the cup to put on top to allow bj section (with snap ring) to go through is too tall. Mother effer. Put everything back together and try in a few weeks when time permits...


WHICH BJ TOOL THAT I CAN RENT/LOAN HAS more cups with different heights that i can loan?

__________________
2010 2.3 Stick Reg Cab XL - Maxtrac 2 inch coils - Bilstein 5100 front shocks - Bilstein yellow rear shocks