View Single Post
 
Old 12-01-2016, 11:24 AM
horizon94 horizon94 is offline
Ford Ranger Driver
 
Join Date: Sep 2012
Posts: 619
Default Re: Remote Start Install Assistance

So here's what I'm working with:


These are the directions that go along with the Xpresskit PKALL:




These are the directions that go along with the Avital 4103:




I also found these instructions online for a similar BullDog system:




Sent from my SM-N910V using Tapatalk

----------

I don't care about any of the anti-theft stuff so if I can ignore any of those wires that'll be a plus. The door locks I can finish myself (haven't had any time). I would like to know what remaining wires are necessary for the remote start.

1)My first question involves D2D. I believe that allows me to connect to an external computer and read information from the ranger. I don't want/need to do that so I'm assuming I can install without D2D. The directions say to cut the connector but then connect to a +12V source. Is that a constant source or ignition ON source?

2) I have no idea what any of the satellite harness connections mean or where those wires would be located.

3) I don't plan on using any of the anti-theft stuff so the only wire I would need on the 5-pin remote start harness would be the tachometer input, right?

4) I also have no idea where to start with the 9-pin Main Harness.



Sent from my SM-N910V using Tapatalk
__________________
2000 Ford Ranger XLT Ext. Cab - 4.0L - 4WD - 3" BL - AAL - Maxed T-Bars - 16" Mickey Thompson Classic Locks - 265/75/16 Cooper AT3s - 12" Power Acoustik Sub @ 1200 watts

Last edited by horizon94; 12-01-2016 at 11:49 AM.
Reply With Quote