View Single Post
Old 12-10-2010, 03:49 PM
JGiddy JGiddy is offline
Join Date: Jul 2010
Posts: 2,682
Default Re: Can I use the A/C control panel thing out of a sport trac?

Originally Posted by Mikerider View Post
Heres how I did mine...

First start by removing the radio bezel and unbolting the HVAC control and removing the control knobs, then use a small screw driver the loosen the clips holding the stock black gauge overlay onto the white control unit. Also remove the silver overlay from the expo controls in the same fashion.

When your done it should look like this

Now press the silver overlay into the stock ranger controls.

Nice snug fit

Reinstall the knobs

Put everything back together and this is what you end up with.

I also installed a set of T5 led to replace the stock bulbs at the same time.

Tiny little suckers.

Hope this helps

You left out the part where you have to cut out a piece of plastic from the expo faceplate in order for it to fit onto the Ranger housing because the notch on the Ranger housing is in a different location than the one on the expo housing. Its not possible to snap it in all the way around until you do this.

and I used these led's in kool white
very bright and no hot spots!

Last edited by JGiddy; 12-10-2010 at 04:45 PM.
Reply With Quote