Quote:
Originally Posted by imshifting
so just unbolt the bell housing and pull it off? I am just replacing the transmission and not the clutch so is there really any reason to disconnect it? Is the only reason to disconnect the pedal and slave cylinder a precautionary measure in case someone pushes down the clutch pedal?
|
Yeah...basically...There should be a electrical plug or two on the trans for reverse lights and such...Just Take off the drive shaft, cross member, then unbolt the trans from the engine (but make sure something is holding it up obviously)
FORGOT TO MENTION! you might have to take the exhaust off too...I think we took it off when we replaced the clutch plate but I dont remember when we did the slave cylinder because I was working on the tailgate while my buddy did the slave cylinder.